DieHard 28.71219, Руководство оператора

Страница: 14 / 20

11
ChECK BATTERY (red) LED blinking: Indicates the charger is in
abort mode.
ChARgINg (yellow) LED lit: Indicates the charger is charging
the battery.
ChARgED (green) LED lit: Indicates the battery is fully charged and
the charger is in maintain mode .
NOTE: See the Operating Instructions section for a complete
description of the charger modes.
OPERATINg INSTRUCTIONS 11.
This battery charger must be properly assembled in
accordance with the assembly instructions before it is used.
The charger does not have an On/Off switch. Plug the 71219 into
a 120V AC electrical wall outlet only after battery connections have
been made and the Amp/Volt selector switch has been set.
NOTE:
This charger is equipped with an auto-start feature. It will not
supply current to the battery clips until a battery is properly connected.
Meaning, the clips will not spark if touched together.
Charging
Ensure that all of the charger components are in place and in 1.
good working condition, for example, the plastic boots on the
battery clips.
Connect the battery following the connection instructions
2.
described in Using the Quick-Disconnect Cable
Connectors section.
Set the Amp/Volt Selector switch to the proper setting for the
3.
battery being charged.
Connect the AC power following the precautions listed in
4.
section 8.
If you’ve connected everything correctly, the CHARGING
5.
(yellow) LED should be lit indicating that the charger is
charging. If the CHARGING (yellow) LED does not light or if
the CHECK BATTERY (red) LED is lit, check the connections
or have the battery checked/replaced.