Connecting orifice plate
9.2
9.2
System unit
The device must be fully disconnected from the supply voltage when performing any work at the device
and when plugging in or disengaging data cables. To completely disconnect the appliance from the
mains voltage, switch off the device and pull out the AC plug to the power supply unit. Peripherals may
not be plugged into the system when it is switched on!
Example of a connecting orifice plate:
1
3 x D-Sub (COM2*-COM4*- inter-
faces, with power supply or 5 x D-
Sub
2
Display 2 (DVI-D/PLINK2) with RMT for one Mx
and Rx Board,
without RMT with one Kx Board
3
1 x D-Sub (COM1 interface)
4
Display 1 (DVI-D/PLINK2) with RMT
5
15-pin Mini D-Sub socket (VGA)
6
Mini DIN (KYBD), keyboard
7
2 x USB-A (USB 2.0)
2 x USB-A (USB 3.0)
8
RJ socket (LAN)
9
3 x 3.5 mm jack bush (IN, Out,
Microphone)
10
3 x PoweredUSB 12 V (with a K1/K2, M1/M2 or
R1/R2-Motherboard)
01750341829F
9-3
Содержание BEETLE/M-III
