INSTALLATION INSTRUCTIONS
NI TB-2630B
Terminal Block for the NI PXI-2530B
This guide describes how to install and connect signals to the National Instruments TB-2630B terminal
block to configure your NI PXI-2530B switch module as one of the following:
•
1-wire 128 × 1 multiplexer
•
1-wire dual 64 × 1 multiplexer
•
1-wire quad 32 × 1 multiplexer
•
1-wire octal 16 × 1 multiplexer
•
2-wire 64 × 1 multiplexer
•
2-wire dual 32 × 1 multiplexer
•
2-wire quad 16 × 1 multiplexer
•
4-wire 32 × 1 multiplexer
•
4-wire dual 16 × 1 multiplexer
•
independent
This terminal block is a shielded accessory.
Contents
Introduction.......................................................................................................................................... 1
1. Unpack the Terminal Block ............................................................................................................. 2
2. Verify the Components .................................................................................................................... 2
3. Connect Signals ............................................................................................................................... 2
4. Install the Terminal Block ............................................................................................................... 20
Accessories .......................................................................................................................................... 21
Compliance and Certifications............................................................................................................. 22
Introduction
The NI TB-2630B terminal block installs in front of the NI PXI-2530B switch module. The
NI TB-2630B has ribbon cable headers to connect signals to the switch. Screw terminals for the trigger
input and trigger output signals are also available. The NI TB-2630B is designed for use with the
NI PXI-2530B and is not compatible with the NI PXI-2530.
̭͈Ρ΅νιϋΠ͉ͅȂུࢊβȜΐ͜܄̞̳ͦ̀͘͘ȃ
