14
Before using, always check that the two bolts on each cutter block are properly tightened.
Using a loose block will result in damage to block and housing. Also check the condition
of the cutter blocks. If either cutting edge is dull or chipped, remove the retaining bolts
and rotate both blocks so that two new edge come into use. Replace and tighten the bolts.
Each block has four cutting edges. When all four cutting edges have been used or if either
block is cracked or otherwise damaged, replace both blocks.
CAUTION:
A loose or cracked block may result in injury to the operator.
Instruction that replacement of the plug or the supply cord shall always be carried out
by the manufacturer of the tool, distributor or service organization.
Return the unit to an authorized distributor for overhaul at least once every two years,
sooner if subject to heavy use.
Ignorance of proper operating procedures can lead to accidents.
If you have any other questions about any procedures, please contact the nearest
authorized distributor.
DIAMOND rebar cutters are recommended to use under 40 degrees Celsius and 75%
humidity for limitations on ambient conditions.
NOISE EMISSION
1.
The nose emission, measured in accordance with 1. 2, as follows.
-
A weighted emission sound pressure level L
pA
and its uncertainty K
pA,
where L
pA
exceeds 70dB (A).
Where L
pA
does not exceed 70dB (A), this fact shall be indicated.
-
A weighted sound power level L
wA
and its uncertainty K
wA
, where the A weighted
emission sound pressure level L
pA
exceeds 80dB (A).
-
C weighted peak emission sound pressure level L
pCpeak,
where this exceed 63Pa
(130dB in relation to
20μPa).
2.
Recommendation for the operator to wear hearing protection.
CUTTER BLOCKS
PLUG OR CORD
OVERHAUL
