29
Check the monitor's colour settings. Press the
Menu
button to
open the OSD, select
Recall
and the press
Menu
. Select
Colour Recall
and press
Menu
to restore the factory colour
settings.
3. No image is displayed, what can I do?
Check that you have selected the correct input. Press the Input
button to change the signal source.
Check that the light (LED) next to the monitor’s power button is
lit and is green in colour. If the LED is green, press the
Menu
button on the monitor to access the On Screen Display. If the
message
NON PRESET MODE
appears there, please read
chapter 6, Setting the Display Resolution and reset the
graphics card to one of the monitor’s supported graphics
signals.
If the LED is orange the monitor is in power saving mode.
Press a button on the computer’s keyboard or move the mouse
to wake the computer. If that does not help, check that the
signal cable is securely plugged into the monitor and the signal
source. Also check the pins of the signal cable’s connectors. If
any pins are bent or broken off, then the cable will need to be
replaced.
If the LED is not lit at all, check that the the power supply is
plugged into the monitor and into a mains socket and that the
mains power switch is turned on. Check that the monitor’s
power switch is also turned on.
4. The image is or distorted, flashes or flickers.
Check that the monitor's signal cable is securely connected to
the computer.
Read the chapters 6 and 7 of this manual, then select the
correct resolution, refresh rate and make adjustments based
on these instructions.
