18
tab and click the
Advanced Properties
button.
3. Select the
Adapter
tab. The refresh rate selection field is
located in the centre, at the bottom of the dialogue box.
4. Choose a refresh rate that corresponds with one of the
factory modes from the table below.
5. Click
Apply
, and then
OK
twice.
Please Note:
◆
Graphics modes that are not listed in the table may not be
supported. For an optimal picture it is recommended that
you choose a graphics mode with a resolution of 1600x
1200pixels that is listed in
Table 1
on the next page. All 10
modes are compatible with Microsoft Windows. Resolutions
of 640 x 480, 800 x 600, 1024 x 768, 1280 x 1024 and 1600
x 1200 pixels are supported by most other operating
systems, including the Apple Macintosh's Mac OS
.
◆
The displayed image may show some distortion or noise.
This can be caused by the signal from the VGA card if it
does not correspond with the usual standard. This is not,
however, a problem with the monitor. If some distortion is
still visible after using the Automatic adjustment, you can
usually improve the displayed image by manually adjusting
the phase, horizontal position and pixel frequency settings.
See Chapter 7,
Adjusting the Monitor
, for more details
.
◆
When you shut Windows down you may see interference
lines on your screen. This caused by the manner in which
Windows controls the graphics card at this point and is
normal with all LCD monitors
.
◆
To extend the service life of the product, we recommend that
you use your computer's power management functions to
turn the monitor off after extended idle periods
.
