Diamond Products CC2525H, Руководство оператора

Страница: 30 / 40

CC2525H OPERATOR’S MANUAL
Lubricate the Transmission Jack shaft
Bearings
1. Locate the two transmission bearing fittings
and add no more than two pumps of
grease to each of the bearings grease
fittings.
200 Hour Service
Replace Engine Oil and Filter
•
Refer to the engine operator’s manual for
oil specifications and capacities.
•
Refer to the engine operator’s manual for
oil filter specifications.
• Ensure the engine is turned off and
sufficiently cooled down prior to draining
the engine oil.
1. Ensure the saw does not have a blade
attached and is level to the ground.
2. Place a drain pan beneath the drain hose
located on the front of the saw.
3. Remove and wipe clean the engine oil
dipstick and set aside.
4. Remove the pipe plug from the end of the
drain hose and allow the oil to drain
completely.
5. Remove the belt guard from the left side of
the saw.
6. Remove the oil filter located on the left side
of the engine.
7. Wipe the filter head area clean with a lint
free cloth.
8. Apply a thin film of oil to the rubber gasket
of the new filter.
9. Install the new filter and hand tighten to
secure.
10. Remove the oil fill cap from the front of the
engine.
11. Fill the engine crankcase with oil in
accordance with the engine manufacturer’s
specifications and capacities.
12. Replace the oil fill cap and reinstall the
engine dipstick.
13. Start the engine and check for leaks. Stop
the engine, correct the leaks and recheck
the oil level using the dipstick.
14. Reinstall the belt guard on the left side of
the saw.
15. Dispose of the used oil and filter in
accordance with city, state and federal
regulations.
Clean the Air Filter
1. Unlock the air cleaner cover clips and
remove the cover.
2. Remove the filter element from the air
cleaner case.
3. Inspect the filter and replace it if it is
damaged.
4. Tap the filter element several times on a
hard surface to remove dirt or blow low
pressure compressed air through the filter
from the inside (not to exceed 30 psi / 207
kPa).
NOTE: DO NOT brush the dirt off of the filter
element as this will force dirt into the fibers.
5. Wipe dirt from inside the filter body and
cover using a moist rag.
CAUTION
Be careful not to allow dirt into the air
chamber that leads to the fuel injection
system. This can lead to engine failure.
6. Reinstall the filter element.
7. Reinstall the air cleaner cover to the air
cleaner case by aligning the clips of the air
cleaner cover with the grooves on the air
cleaner case.
8. Lock the air cleaner clips securely.
300 Hour Service
Replace Spark Plugs
1. Disconnect the spark plug wire.
2. Remove the spark plug using a 13/16”
spark plug wrench.
3. Check the spark plug gap on the new plug
with a wire type feeler gauge. Correct the
gap if necessary in accordance with the
specifications called out in the engine
manufacturer’s manual.
4. Carefully install the spark plug by hand until
it is seated.
5. Tighten the spark plug 1/2 turn using the
applicable spark plug wrench to compress
the sealing washer.
6. Reconnect the spark plug wire.
7. Repeat these steps for the second spark
plug.
30