DIAMOND DRYERS DIAMOND PLUS GWHD22, Руководство по установке, Страница: 5 / 8

4. ATTACHING MIAN BODY
4.1 Place the main cover of the backplate (fig. 7).
4.2 Insert and tighten the (2) security screws into the side of the main body with the service tool (fig. 8)
3. Installing Power cable & Connection terminal block
WARNING: ENSURE POWER NOT CONNECTED
3.1 Pull the cable through the the grommet. Ensure the cable is long enough to route correctly through the
backplate to the terminal block (fig 6).
3.2 The cable must sit in the dedicated channel.
3.3 As shown, connect cable to terminal block and screw in terminal block.
3.4 Fix the cable clamp with screw in the backplate (fig 6A).
(In case without built in power cable)
6
CAUTION: Connect the ground wire to the terminal block marked “ ”
Do not over-tighten and crush the power cable.
6
EN
L
N
6mm
Grommet
(cable entry)
Cable clamp
(In case without
built in power cable)
4.2 Give power to the electrical system.
4.3 Check the power switch on (factory default setting “ON”).
4.4 Test the unit for correct operation. The LED light on the cover should flash 5 times with a red light after
the power supply has been correctly connected and followed by continuous light white LED.
7 8