Diamond Diagnostics Prolyte, Руководство по обслуживанию

Страница: 35 / 41

P R O L Y T E A N A L Y Z E R
3.o
Probe Motor Assembly Removal
1. Detach the screw at the top of the probe position locator, using a Phillips head screw driver, as
shown in figure below. Remove the washer.
2. Remove the probe position locator.
3. Remove the retaining ring from the actuator, using the retaining ring pliers. The retaining ring must
be replaced once removed. DO NOT stretch out the retaining ring with the pliers. Disengage the
actuator from the top of the lead screw assembly.
▲ Save the retaining ring.
4. Detach the three screws from the probe motor bracket, using a Phillips head screw driver, as
shown in Figure P14.
5.
Remove the probe motor/lead screw assembly.
3.p
Probe Motor Assembly Installation
1. Place the probe motor assembly into place. See Figure P14.
2. Attach the three washers and screws to the probe motor assembly bracket, using a Phillips head
screw driver. See Figure P14.
▲ The other two screws are located on the bottom edge of the bracket.
3.
Insert the actuator through the top of the lead screw assembly. Install the retaining ring onto the
actuator using the retaining ring pliers. DO NOT stretch out the retaining ring with the pliers.
4.
Place the probe motor cable wires into the retaining clamp. Secure the wires to the sensor cable
wires with a tie wrap cable.
The optimum location for the tie wrap cable is slightly to the left of the retaining clamp.
5. Install the solutions valve.
6. Remove the black thumb grip from the solutions valve. Install the sample probe as normal. Refer
to Figure P14 for details.
A. With the probe hole facing to the left, toward the inside body of the proLYTE,
align the probe collar with the notch on the top of the probe arm. When
aligned, snap the probe into the probe arm.
32