INTRODUCTION
Thank you for purchasing a DIAMAPRO® SYSTEMS product.
This manual provides information and procedures to safely operate and maintain the WVX Wet Vacuum.For your own safety and protection from injury,
carefully read, understand, and observe the safety instructions described in this manual.
Keep this manual or a copy of it with the machine. If you lose this manual or need an additional copy, please contact DiamaPro® Systems. This machine
is designed and built with user safety in mind; however, it can present hazards if improperly operated and serviced.
Please follow the operating instructions carefully. If there are any questions regarding operating or servicing of this machine, please contact DiamaPro®
Systems customer service at 470-977-2323.
We also recommend that you visit our website www.diamaprosystems.com for the fastest, most efficient way to complete your product registration and
see other DiamaPro Systems’ products and accessories to meet your cleaning needs.
DISCLAIMER: DiamaPro and its affiliates take no responsibility for any damage, injury or death resulting from the incorrect or unsafe use of this product.
Use of this product should be undertaken by competent persons only. It is the operator’s responsibility to ensure that the following safety procedures are
followed. If you are unsure, do not operate this product.
WARRANTY
OPERATION
BEFORE EACH USE
(1) This vacuum cleaner is designed for wet only pickup. Please avoid picking up dry materials.
(2) Make sure the tank is clean, and that there is no debris in the tank.
(3) Make sure the mesh filter bag is installed on the inlet inside the canister. The bag should be empty, and the slide-on clamp should be installed on the
bottom of the bag. Position the thin, flat plastic strip that is attached to the mesh filter bag, over the rim of the canister. This strip helps retain the bag
when it fills with debris.
(4) Make sure that the float mounted on the underside of the motor head is able to move freely, and that the filter on the outside of the float housing is
clean and properly in place. This filter will protect the vacuum motor from debris.
(5) Attach the motor head to the canister using the two metal clamps mounted on the side of canister.
(6) Attach the long discharge hose to the brass fitting on the rear of the canister. The fitting is a ball coupling type. Pull the collar of the female brass
fitting toward the canister before inserting the hose fitting.
TO OPERATE
(1) The vacuum cleaner motor is controlled by the switch on the top left side of the motor head.
(2) The liquid in the canister can be emptied using the short, black, corrugated hose attached to the rear of the canister. Be sure the end of the hose is
securely attached to the stationary drain hose plug after use.
(4) Check the mesh bag frequently for debris. To empty, remove the bag from the canister and slide off the retaining clip on the bottom of the bag. Rein
-
stall the mesh filter bag before continuing to use the vacuum.
Do not operate the vacuum without the mesh filter bag in place
NEVER LUBRICATE THE VACUUM CLEANER MOTOR. THE MOTOR BEARINGS ARE PERMANENTLY
SEALED. THIS VACUUM IS INTENDED FOR INDOOR OR OUTDOOR USE AND FOR WET PICKUP, BUT
IT IS NOT INTENDED TO BE EXPOSED TO RAIN.
DiamaPro Systems’ WVX model vacuums are warranted to be free from manufacturing defects in normal service for a period of one or two years from
the date of purchase by the original consumer purchaser. Component manufacturers offer separate warranty periods. Call 470-977-2323 for complete
information.
DiamaPro System’s obligation under this warranty is expressly limited to the replacement of such part or parts as inspection shall disclose to have been
defective.
This warranty does not apply to defects caused by damage, unreasonable use, faulty repairs made by others or defects caused by failure to provide
reasonable maintenance.
Further, the warranty is void if the product, or any of its components, is altered or modified by the consumer or if the product is used in an inappropriate
manner or with equipment not recommended by the manufacturer.
Wear items are not covered under warranty: examples include: belts, wheels, casters, bearings, cart wheels, filters, wear pads, spark plugs, hoses,
wands and squeegees, motors, etc.
To qualify for warranty coverage, DiamaPro WVX vacuums must be registered within 30 days of purchase. Registration can be completed online at
www.DiamaProSystems.com.
To request your warranty service you MUST send a written request to the dealer or directly to the manufacturer including the manufacturing details that
can be found on a plate fitted inside your machine together with a copy of the invoice.
