LCS Pro units
— User Manual
Version 1.14
Page 21 of 43
The Send all settings button will update the LCS Pro unit with all
settings in the textboxes (the user configurable commands and
responses) and all check boxes.
The Change Baud button (there is no corresponding command) will
ask for a new baud rate and will update the LCS Pro unit with this
information. (The host will send a reboot commando to the LCS Pro
unit and will keep sending “U” (capital U) characters till the unit has
copied the hosts baudrate). The new baudrate is now actual.
If the yellow screen does not disappear remove power to the LCS Pro
unit and apply the power again. The yellow screen will disappear
now and the U-string is followed by the “Unit on” command.
Update Subtype
The Update Firmware button will ask for a firmware file. After
giving the exact location of this file (usual windows explorer
window) the new software (Lcspx_yz.scr) will be uploaded to the
unit automatically which is indicated by a red/green flashing status
button.
If the firmware update doesn’t start automatically (status button not
flashing) remove the power from the LCS Pro unit and reconnect
power again. While the status button is flashing, make sure the unit is
not being switched off, and the power is not interrupted. This process
takes about one minute and should not be aborted by any means.
While updating a progress bar shows the current progress.
When ready the progress bar disappears and the U-string is followed
by the “Unit on” command.
A Firmware update should be done at a communication speed
(baudrate) of 9600 baud, a low speed slows down the update process.
Change the baudrate to 38400 baud to speed up the update process.
Don’t forget to restore the original baudrate after the firmware
update.
The Update Firmware button can also be used for a Firmware
Subtype Update. In this case choose the required subtype upload file:
<LCS Pro_serial_number>_1-x.scr (x = 1, 2, 3, 6 or 7).
Содержание LCS Pro EM
Страница 1: ...User Manual Version 1 14 ...
Страница 10: ...LCS Pro units User Manual Version 1 14 Page 10 of 43 ...