Document No: 9100-127-1958-99 Rev F
Release Date: 10/8/15
1501 Route 34
South, Farmingdale, NJ 07727 Tel: (732) 919-3119 Fax:
(732) 751-5778 www.dialight.com
•
DO NOT let any supply cords touch hot
surfaces higher than cord ratings.
•
DO NOT mount near gas or electric heaters
•
Equipment should be mounted in locations and
at heights where it will not be subjected to
tampering by unauthorized personnel.
•
The
use
of
accessory
equipment
not
recommended by the manufacturer may cause
unsafe conditions.
•
DO NOT use this equipment for other than
intended use.
•
DO NOT look into the Infrared (IR) LEDs. These
five IR LEDs on top of the unit (if applicable) will
not appear to be ON, but can
be verified using
most digital cameras.
•
Pictures
are
required
for
commissioning the install. Failure to
provide could VOID all warranties
SAVE THESE INSTRUCTIONS!!
•
The operation and maintenance must be carried
out by authorized personnel.
•
Repairs and Installation must only be carried out
by a qualified electrician.
•
Only genuine Dialight replacement parts must be
used when unforeseen repairs are required.
•
Observe the national safety rules and regulations
during installation!
•
Earth Grounding is required throughout the
install process. Failure to do so could void all
warranties!
•
No alterations should be done without the
agreement from Dialight Corp. Alterations other
Than written in this manual will void all
warranties.
Instructions must be kept with the system installed
Introduction:
This manual is for orientation of the controller, configuration and definitions of the Dual
Strobe system or Dual Infrared (IR) system.
Refer to the installation manual for the following information
• Installing the Controller and the pre drilled holes
• Dimensions of the Controller
• Securing the cables to the structure
• Connection of either AC or DC input voltages
• Connection of the Side lights and calibration
• Photocell connections
• Flashhead connections for both the 4 conductor and the 8 conductor versions
• Proper bonding of the Strobe cable
• Mounting the Flashhead.
Medium Intensity Quick Start Manual
READ AND FOLLOW ALL SAFETY INSTRUCTIONS