Dhollandia DH-S Series, Руководство по установке

Страница: 51 / 82

50
DHOLLANDIA
Figure 14.1
Figure 14.3
Figure 14.2
14 COMMISSIONING AND QUALITY CONTROL
•
Finish the liftgate in accordance with local regulations.
•
Execute all functions min. 5 times to ensure the liftgate functions correctly. Pay special attention to:
1. Smooth and quiet operation through the full range of motion of the platform.
2. Auto tilt at ground level.
3. Correct alignment of the open platform flush with the extension plate.
4. Correct stowage of the liftgate in its travel position.
•
Make sure that the liftgate will be clearly visible in surrounding traffic [Figure 14.1]:
1. Apply the RD/WH conspicuity tape on both sides of the platform.
2. Fit the platform flags to the underside of the flip-over point.
3. If applicable: connect the flashing platform lights (if not prewired) and verify their function.
•
If the operator is allowed to travel up and down on the platform, it is strongly recommended to paint a safe- work zone of 16”x16”
(406mm SQ) at a safe distance of 10” (254mm) removed from the hazardous crushing area between the inboard platform edge and
the extension plate. [Figure 14.2 – 14.3]
•
Work through the PDI checklist in the appendix and complete the practical load tests indicated. Fill-out the FITTING DECLARATION.
•
During weight test, verify if the hydraulic pump pressure suits the maximum rated lift capacity in this particular mounting situation.
Adjust the pressure if too high or too low, seal the pressure relief valve after that using the provided tamper-evident cap.