Dhollandia DH-S Series, Руководство по установке

Страница: 48 / 82

47
DHOLLANDIA
•
Grease all nipples in all articulations with acid-free grease. See grease plan in chapter 13.
•
Execute all movements several times to ensure all liftgate functions work properly. Pay special attention to:
1. The correct function of the end stops for the lift arms, and the end stops in the sliding tubes.
2. The correct alignment of the platform in work position, flush with the vehicle floor.
3. The loop of the conduit with the electrical wires from the hydraulic power pack to the control box when sliding the liftgate in
and out.
4. The correct position of the platform buffers.
13 LUBRICATION INSTRUCTIONS
•
All articulation points equipped with lube fittings should be lubricated after installation (pictured on the following page), and once in
service with intervals as indicated in the maintenance manual.
•
Use a grease gun to pump grease in the lube fittings, until a grease collar is formed on both sides of the bearing or articulation,
protecting it against ingress of water, salt, sand and dirt.
•
Note that the grease nipple might be located in the pin itself, or in the larger assembly that pivots around the pin.
•
In case a pin has 2 grease nipples, grease both sides.
•
Ensure all lube fittings function correctly and replace any defective fittings.
•
ALWAYS use acid-free grease. The use of graphite grease is not allowed.
•
If so equipped, verify if the platform lock operates smoothly, and lubricate with oil if necessary.
NOTICE
To maximize the durability and operational reliability of the liftgate, it is important to lubricate the pivot points thoroughly after installation.