Dhollandia DH-S Series, Руководство по установке

Страница: 24 / 82

23
DHOLLANDIA
9 MOUNTING OF THE LIFT FRAME AND SLIDING TUBES
9.1 TEST FITTING THE LIFT FRAME AND SLIDING TUBES
•
Position the lift frame on a wheeled jack (order code M0025) [see 1
on Figure 9.1], or use a similar device to slide the frame under the
chassis of the vehicle. [Figure 9.2]
•
Slide the frame under the chassis and raise the lift arms to the fitting
jigs or the articulation hands on the platform.
•
Slide the articulation pins through the fitting jigs (or platform hands)
and the articulations on the lift arm. [Figure 9.3]
•
If it is difficult to raise the lift arms or to present the frame in the correct
fitting position, disconnect the forks of the cylinders from the lift arms
[see 2 in Figure 9.1].
•
Raise it to the fitting height MFT [see section 6.4].
•
While doing this, do not force either side of the frame higher or lower
than the position it is taking naturally without exercising any special
force.
•
From the side of the lift, ensure the top face of the lift frame is
perfectly parallel with the body and the chassis. [1 in Figure 9.4]
•
If applicable (not for SM.80, SMP… with integrated side plates), fit
the slide plates over the frame and mount the front brackets,
washers, and M24 nuts loosely. Do not tighten the nuts at this stage.
[2 in Figure 9.4]
•
Refer to the FITTING DRAWING to determine the distance (L) from
the rear side of the sliding tubes to the end stops. [Figure 9.]
•
If not drawing is available, this distance depends on how / where the
platform buffers are mounted [see Figure 9.5
– 9.6]. Approximate
values.
•
For aluminium sliding tubes, fasten the toothed racks [3 in Figure 9.6]
just in front of the end stops at an equal distance from the edge of
the sliding tubes (left and right).
Figure 9.1
Figure 9.2
Figure 9.3
❶
❷
⚠