Tel/Fax: 0755-82734836
www.dh-robotics.com
3
Figure 1.3 control box
2 Description of control box
2.1 control box
The clamping claw is equipped with a control box, which is mainly used to control the
opening and closing of the electromagnetic claw. As shown in Figure 2.1:
图
2.1
控制器
Through the dialing control inside the control box, as shown in the red box in Figure 2.2
below. The IO input signal of gripper can be set to NPN or PNP.( Input 0V valid or 24V valid)
Instructions
·
Indicator
：
When the signal is given to the electromagnetic gripper, the indicator light
will be on, but if the signal is not given, the indicator light will be off.
·
Dial switch:
manually control the opening and closing switch of electromagnetic gripper.
·
Gripper interface:
used to connect the cable of electromagnetic gripper.
