Chapter 7 BIOS Setup
www.dfi.com
36
Chapter 7
Network Device List
The “Device Manager” screen is displayed. And if the “Network Stack” or the “PXE Boot
to LAN” option is enabled from the “Boot” menu, the “Network Device List” should
be shown in the “Device list”. Select “Network Device List” to view all of the detected
network devices. For each network device, you can select to view and configure its
settings. In addition, you can select either the IPv4 or IPv6 network settings for UEFI
network configuration.
NIC Configuration Menu
This screen shows hardware information for the Ethernet controllers and configures
their operation.
Blink LEDs
Enter the duration (seconds) to blink the Ethernet’s Speed LED to indicate its presence.
NIC Configuration
This screen configures the Ethernet controller. Select the link speed from the following op-
tions: Auto Negotiated, 10Mbps Half, 10Mbps Full, 100Mbps Half, and 100Mbps Full.
IPv4 Network Configuration
This screen configures the IP addressing method (DHCP or static IP). For static IP ad-
dressing, configure the following:
Local IP address and subnet mask: Enter the IP address for the network device in the
IPv4 format:
x . x . x . x (x must be a decimal value between 0 and 255).
Local Gateway: Enter the gateway address in the IPv4 format.
Local DNS (Domain Name System) Servers: Enter DNS (Domain Name System) server IP
addresses in the IPv4 format.
