75
3
Award BIOS Setup Utility
UART Mode Select
The mainboard supports IrDA function for wireless connectivity
between your computer and peripheral devices. You may not use
IrDA (J15) and the COM 2 (J4) serial port at the same time. If you
are using the COM 2 serial por t, make sure this field is set to
Normal.
To use the IrDA function, follow the steps below.
1.Connect your IrDA cable to connector J15 on the mainboard.
2.Set the “UART Mode Select” field to the type of IrDA standard
suppor ted by your IrDA peripher al/device . For better
transmission of data, your IrDA peripheral device must be within
a 30
o
angle and within a distance of 1 meter.
3.Set the “RxD TxD Active”, “IR Transmission Delay”, “UR2 Duplex
Mode” and “Use IR Pins”
fields appropriately.
RxD, TxD Active
The options are Hi, Lo; Lo, Hi; Lo, Lo; and Hi, Hi.
IR Transmission Delay
If this option is Enabled, transmission of data will be slower. This is
recommended when you encounter transmission problem with your
device. The options are: Enabled and Disabled.
UR2 Duplex Mode
Half
Data is completely transmitted before receiving data.
Full
Transmits and receives data simultaneously.
Use IR Pins
The options are IR-Rx2Tx2 and RxD2, TxD2.
Onboard Parallel Port
378/IRQ7, 3BC/IRQ7, 278/IRQ5
Selects the I/O address and
IRQ for the onboard parallel port.
Disabled
Disables the onboard parallel port.
