DFI P5BVP, Руководство пользователя

Страница: 9 / 82

1
Introduction
9
USB Ports
The system board is equipped with two connectors for external
USB ports. USB allows data exchange between your computer and
a wide range of simultaneously accessible external Plug and Play
peripherals.
BIOS
• Award BIOS, Windows  95 Plug and Play compatible
• Flash EPROM for easy BIOS upgrades
Power Supply Connectors
The Baby AT form factor system board is designed to fit into an
ATX form factor chassis. The board is equipped with both ATX and
AT power supply connectors.
Jumper JP10 must be set according to the type of power supply
installed in your computer. Refer to “Jumper Settings for Power
Supply Type” (Chapter 2) for the proper settings.
Using an ATX power supply, you can either shut down your com-
puter by pressing the Power button located on the front bezel of
your computer or by executing the Shut Down command under the
Windows
 95 operating system. Your system will then enter the “Soft
Off” state.
To power-on your system automatically, enable “Resume On
Alarm” in the Power Management Setup of the Award BIOS. This
will allow you to set the date and time you would like your
system to power-on.
1.1.2 Technology
SDRAM (Synchronous Dynamic Random Access Memory)
The system board supports unbuffered SDRAM memory. SDRAM
is a DRAM technology that uses the clock on the chip to
synchronize with the CPU clock so that the timing of the memory
chips and the timing of the CPU are synchronized. This saves time
during transmission of data, subsequently increasing system
performance.