DFI P5BVP, Руководство пользователя

Страница: 33 / 82

2
Hardware Installation
33
2.2.5.4 Floppy Disk Drive Controller
The system board is equipped with a shrouded floppy disk header
that supports two standard floppy disk drives. To prevent
improper floppy cable installation, the shrouded floppy disk header
has a keying mechanism. The 34-pin connector on the floppy cable
can be placed into the header only if pin 1 of the connector is
aligned with pin 1 of the header.
Connecting the Floppy Disk Cable
1. Install the 34-pin header
connector into the shrouded
floppy disk header (J8) on
the system board. The
colored edge of the ribbon
should be aligned with pin 1
of connector J8.
2. Install the other 34-pin
header connector(s) into the
disk drive(s). Align the
colored edge of the daisy
chained ribbon cable with pin
1 of the drive edge connector(s). The end-most connector
Connecting the Parallel Printer Port
Attach the DB-25 printer port
cable to connector J7 on the
system board. Make sure the
colored stripe on the ribbon
cable aligns with pin 1 of J7. Use
a small nutdriver to mount the
cable into a DB-25 cutout in the
system chassis. If your printer
port cable is attached to a card-
edge bracket, connect the cable
to connector J7 on the system
board and mount the card-edge
bracket to the system chassis.