www.dfi.com
30
Chapter 6 Mounting Options
Chapter 6
Panel Mount
The panel mount kit includes the following:
•
10 mounting clamps
Note:
The system unit used in the following illustrations may not resemble the actual one.
These illustrations are for reference only.
Please use the following procedure to mount your system:
1. Select a place on the panel (or wall) where you will mount the Panel PC.
2. Cut out a shape on the panel that corresponds to the Panel PC’s rear dimensions (396.2mm
x 246.5mm) and ensure that the Panel PC can be fitted into the panel properly.
Front view
396.20
246.50
R10.90
272.30
422
A
16
(x10)
4
(M
ax)
Panel
Mounting hole
3. Insert the Panel PC from the outside surface of the panel into the mounting hole until it is
properly fitted against the panel.
4. Position the mounting clamps along the rear edges of the Panel PC and insert them into the
slits around the Panel PC.
Slit for mounting the clamp
Mounting clamp
flat top
5. The first and second clamps must be positioned and secured diagonally prior to mounting
the rest of the clamps. Tighten the clamp’s screw using an electric screwdriver by pressing
the white plastic cap onto the back of the panel. The illustration below shows that all
clamps are properly mounted.
272.30
422
16
(x10)
Rear view