58
3
Award BIOS Setup Utility
system and remove the battery. Wait for a
few seconds and install it back before
powering-on the system.
Hot Key
When this option is selected, move the cursor to
the KB Power On Hot Key field to select a
function key you would like to use to power-on the
system. The options are from Ctrl-F1 to Ctrl-F12.
Mouse Left
When this option is selected, double-click the left
button of the mouse to power-on the system.
Mouse Right
When this option is selected, double-click the right
button of the mouse to power-on the system.
Any Key
Press any key to power-on the system.
Keyboard 98
When this option is selected, press the wake up
key of the Windows
98 compatible keyboard to
power-on the system.
Onboard FDC Controller
Enabled
Enables the onboard floppy disk controller.
Disabled
Disables the onboard floppy disk controller.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto
The system will automatically select an I/O address for
the onboard serial port 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
Allows you to
manually select an I/O address for the onboard serial
port 1 and serial port 2.
Disabled
Disables the onboard serial port 1 and/or serial port 2.
UART2 Mode Select
The system board supports IrDA function for wireless connectivity
between your computer and peripheral devices. You may not use
IrDA (J12) and the COM 2 serial port (J11) at the same time. If
you are using the COM 2 serial port, make sure this field is set to
Normal.
To use the IrDA function, follow the steps below.
1. Connect your IrDA cable to connector J12 on the system
board.
