2
Hardware Installation
37
2.9.15 Wake-On-LAN Connector
The system board supports the Wake-On-LAN function. This
function will allow the network to remotely power-on a Soft Power
Down (Soft-Off) PC. However, if your system is in the Suspend
mode, you can power-on the system only through an IRQ or DMA
interrupt.
To use the Wake-On-LAN function, you must enable the Resume
on LAN field in the Power Management Setup of the BIOS. Your
LAN card package should include a cable. Connect one end of the
cable to the wakeup header on the card and the other end to
location J10 on the system board. The network will detect Magic
Packet and assert a wakeup signal to power-up the system. Refer to
the add-in cards manual for details. Note: Your LAN card must
support the remote wake up function.
Important:
The 5VSB power source of your power supply must support
≥
720mA.
Pin
1
2
3
Function
WOL
Ground
+5VSB
