2
26
Hardware Installation
2.8.5 IDE Disk Drive Connector
The system board is equipped with two shrouded PCI IDE headers
that will interface four Enhanced IDE (Integrated Drive Electronics)
disk drives. To prevent improper IDE cable installation, each shrouded
PCI IDE header has a keying mechanism. The 40-pin connector on
the IDE cable can be placed into the header only if pin 1 of the
connector is aligned with pin 1 of the header.
Connecting the IDE Disk Drive Cable
1. If you are connecting two IDE disk
drives, install the 40-pin connector of
the IDE cable into the primary
shrouded IDE header (J20). If you
are adding a third or fourth IDE
device, install the 40-pin connector of
the other IDE cable into the
secondary shrouded IDE header
(J23).
Connecting the Floppy Disk Drive Cable
1. Install the 34-pin header connector
into the shrouded floppy disk header
(J22) on the system board. The
colored edge of the ribbon should
be aligned with pin 1 of J22.
2. Install the other 34-pin header
connector(s) into the disk drive(s).
Align the colored edge of the daisy
chained ribbon cable with pin 1 of
the drive edge connector(s). The end-
most connector should be attached
to the drive you want to designate
as Drive A.
