www.dfi.com
Chapter 3 BIOS Setup
Chapter 3
26
ACPI Settings
This section configures the system ACPI parameters.
Wake on LAN
This field use to enable or disable the LAN signal to wake up the system.
After G3
This field is to specify what state what state the system should be in when power is
re-applied after a power failure (G3, the mechanical-off, state).
Always On
The system is in working state.
Always Off
The system is in soft-off state.
Enable/Disable Wake on
LAN capability.
ACPI Configuration
Wake on LAN <Disabled>
After G3 <Alwasy On>
Advanced
F1
Help
↑/↓
Select Item
F5/F6
Change Values
F9
Setup Defaults
Esc
Exit
←/→
Select Item
Enter
Select
SubMenu
F10
Save and Exit
InsydeH20 Setup Utility
Rev. 5.0
CPU Configuration
This section configures the CPU.
Intel SpeedStep
®
Enable or disable the Enhanced Intel SpeedStep
®
Technology, which helps optimize
the balance between system’s power consumption and performance. After it is enabled
in the BIOS, you can enable the EIST feature using the operating system’s power
management.
Turbo Mode
Enable or disable processor turbo mode (requires that EMTTM is enabled too), which
allows the processor core to automatically run faster than the base frequency when
the processor’s power, temperature, and specification are within the limits of TDP.
Intel Speed Step Technol-
ogy Enable/Disable
CPU Configuration
Intel SpeedStep <Enabled>
Turbo Mode
<Enabled>
Advanced
F1
Help
↑/↓
Select Item
F5/F6
Change Values
F9
Setup Defaults
Esc
Exit
←/→
Select Item
Enter
Select
SubMenu
F10
Save and Exit
InsydeH20 Setup Utility
Rev. 5.0
Note
:
For the “After G3” setting to take effect, make sure that the "AC Power Loss” op-
tion is set to “Always on” in “SIO NUVOTON6106D” of the “Advanced” menu.
