DFI AL9A2, Руководство пользователя

Страница: 34 / 49

www.d fi .com Chapter 4 BIOS Setup
34
Chapter 4
Enables or Disables
BIOS support for security
device. O.S. will not show
Security Device. TCG
EFI protocol and INT1A
interface will not be
available.
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
TPM20 Device Found
Vendor: INTC
Firmware Version: 3.1
Security Device Support
Pending operation
Security
Security Device Support
Enables or Disables the BIOS support for the security device. O.S. will not show the
security device. TCG EFI protocol and TNT1A interface will not be available.
Pending operation
Schedule an operation for the security device.
[Enable]
[None]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Note:
Your computer will reboot during restarting in order to change the security
device state.
Boot
Number of seconds to
wait for setup activation
key.
65535(0xFFFF) means
inde fi nite waiting.
Version 2.18.1263. Copyright (C) 2018 American Megatrends, Inc.
Setup Prompt Timeout
NumLock
Quiet Boot
Network Stack
Boot Option Priorities
Driver Option Priorities
Save & Exit Advanced Security Main Boot

Select Screen

Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
1
[On]
[Disabled]
[Disabled]
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Setup Prompt Timeout
Select the number of seconds to wait for the setup activation key. 65535 (0xFFFF)
denotes indefinite waiting.
NumLock
This allows you to determine the default state of the numeric keypad. By default, the
system boots up with NumLock on wherein the function of the numeric keypad is the
number keys. When set to Off, the function of the numeric keypad is the arrow keys.
Quiet Boot
This section is used to enable or disable quiet boot option.
Network Stack
This section is used to enable or disable UEFI network stack. When Network Stack is
set to enabled, it will display Ipv4 PXE Support and Ipv6 PXE Support.