DFI-ITOX 586ITOX, Руководство пользователя

Страница: 53 / 91

3
Upgrade Guide
53
Off: Disabled
2-3 On: COM 2
(default)
1-2 On: COM 1
1 2 3 1 2 3 1 2 3
1. Set JP10 according to the COM port where your modem is
connected.
2. If your ATX power supply has an On/Off switch, set this to On
so that even when you have shut down (“soft power off ”) your
system, it will always remain in “standby” mode. You can shut
down your computer by executing the Shut Down command
under Windows
®
95.
3. Enable Power Management. This will allow your system to enter
Suspend mode after you have finished accessing data. Refer to
the Power Management Setup section for more information.
Important:
Before connecting your external modem to COM 1 or COM 2,
you must first turn on the power of your modem. This is to
protect your ATX power supply and system against harmful
interference.
Jumper Settings for Modem Ring-on
Jumper JP10
Modem Ring-on Select
The system board supports the
Modem Ring-on feature which
allows the Soft Power Down
(Soft-Off) PC to power on to
respond to incoming calls. With an
external modem installed, you can
remotely transmit or access data
without physically going to your
system. To “power on” your system,
follow the steps below. Make sure
“Resume By Ring” in the Power
Management Setup is enabled.