Dexter Laundry DSC, Руководство по эксплуатации, техническому обслуживанию и ремонту

Страница: 4 / 30

-3-
Dexter Sway Control Mounting
!
CAUTION
This is the safety alert symbol. It is used to alert you to
potential injury hazards. Obey all safety messages that
follow this symbol to avoid possible injury or death.
CAUTION
The Dexter Sway Control should only be installed by a
qualified technician.
DSC Trailer Mounting
DSC Mounting Location
Select a location on the trailer to mount the DSC. The location
must be 5 to 10 feet behind the trailer bumper hitch ball and
shielded from road debris. The DSC must be securely fastened
onto a vertical surface that does not flex or move from wind, such
as plastic covers or plastic walls. The center of the DSC (marked
by a red dot on the DSC label shown below) must be positioned
on the “center line” of the trailer and the DSC must be mounted
with the correct side in the UP direction as indicated on the label.
The longest edge of the DSC (as indicated by a red line on the
label) must be mounted parallel to the trailer axle beam(s). See
Figure 1.
www.dexteraxle.com
Phone: 574-295-7888
Part No. 058-010-00
M O U N T T H I S E D G E U P
Mount this edge parallel with the trailer axle beams 5 to 10 feet back
from trailer bumper hitch ball on a vertical frame surface
Module will not function if
positioned and/or oriented
improperly. Read and
follow all Installation Instructions
to ensure proper operation.
WARNING
Wires Trailer Wire Function
Purple Left side electric brakes output
Pink Right side electric brakes output
White
Trailer battery/frame ground point
Blue Electric brake controller signal from tow vehicle
Black 12VDC from tow vehicle trailer harness
MOUNT THIS POINT ON TRAILER CENTER LINE
MODULE WIRING
CONNECTOR
ON THIS SIDE
Label No. 059-898-00 Rev C
Assembled in the USA by Tuson RV Brakes, LLC.