DewertOkin ID21, Руководство по установке

Страница: 25 / 96

System ID21 Installation
78438 7.0 25
Avoiding a pinching hazard
When designing your product, you should take the lifting column's adjustment movement into
account with passive safety mechanisms and with the appropriate safety notices in your oper-
ating instructions.
• Installation methods for ensuring passive safety: Install the ID21 lifting column so that none
of the positions where shear and pinch hazards exist are accessible externally.

Make sure that your operating instructions inform the user of these safety points.

Structural modifications and improper installation which do not follow the installation steps or
the safety instructions found in these installation instructions may result in serious injuries to
users (e.g. crushing injuries). Structural modifications may only be made after consulting with
DewertOkin and receiving our consent. Follow all instructions from DewertOkin, especially
those found in these installation instructions.
NOTICE
Compliance with the intended usage and other regulations
Any further processing of the products that contradicts the proper and intended usage is forbid-
den.
The manufacturer or installer of the end product must ensure that all legal and regulatory require-
ments regarding the end product's manufacture, installation and customer support are followed.
5.1.2 Selecting the tabletop
The DIN Technical Report 147 describes the following information:
• Corner and edge design
•
Exterior surfaces
• Surface brightness
• Surface finish
•
Min. 3 mm edge radius
This information shall be considered binding when selecting the tabletop.
5.1.3 Ergonomics
The operating instructions that you are creating for the end product must provide instructions for an
ergonomically correct installation where the control keypads are easily accessible and the table is
freely accessible.
5.1.4 Use of the system by the end customer
The operating instructions for the end customer must refer to standards regarding:
• Standards for usage, arrangement of equipment in the working area, the planned activities
and the working postures and positions
• Standards for describing the adjustment mechanisms with instructions for ergonomic ad-
justments
Please refer to the guidelines for the design of screens and office workstations from the German
Trade Association for Printing and Paper Processing (BGI 650).