Operating the control keypads
System DD11 / System DD21
58
82774 2.0
8.5.2 Display functions
The display on the HSF control keypad is a 3-character positional and information display. There are
also 6 information LEDs arranged side-by-side.
LED
Function
Container LED
This LED indicates that the container stop is enabled. (Depend-
ing on controller model in use.)
Reset LED
This LED indicates that a controller reset is being carried out.
(Depending on controller model in use.)
Flex LED
1)
This LED indicates that the Flex function is enabled. (Depending
on controller model in use.)
Ergo-trainer LED
1)
This LED indicates that the ergo-trainer is enabled. (Depending
on controller model in use.)
Info LED
This LED indicates that important information is displayed on the
positional/information display. (Depending on controller model in
use.)
PIN LED
1)
This LED indicates that the PIN CODE function is enabled.
1)
Not available with the SMART/
COMPACT control unit.
8.5.3 Advanced functions
Saving a position
Any table position can be saved using this function.
When the controller is turned on for the first time, all positions are equal to the minimum table po-
sition (the lower end position).
Only one table position can be stored per memory key.
To save a position, proceed as follows:
1
Move the table to the position that you want to save.
073
The position is shown on the display (e.g. 73 cm).
2
Press the Save key.
5 -
S -
is now shown on the display.
3
Press the desired memory key (e.g. 2).
5 2
S 2
is shown on the display.
4
The set table position is now saved for the selected memory key.
A double-click noise can then be heard. After about 2 seconds, the saved table
position is displayed.
