DeWalt XR Li-Ion DCD710-XE, Инструкция по эксплуатации

Страница: 11 / 16

9
Keyless Single Sleeve Chuck
FIG. 5
(Fig. 5)
Your tool features a keyless chuck with one
rotating sleeve for one-handed operation of the
chuck. To insert a drill bit or other accessory,
follow these steps.
1. Lock the trigger in the OFF position as
previously described.
2. Grasp the black sleeve of the chuck
with one hand and use the other hand
to secure the tool. Rotate the sleeve
counterclockwise far enough to accept the desired accessory.
3. Insert the accessory about 19 mm into the chuck and tighten securely by rotating
the chuck sleeve clockwise with one hand while holding the tool with the other. Your
tool is equipped with an automatic spindle lock mechanism. This allows you to open
and close the chuck with one hand.
To release the accessory, repeat step 2 above.
WARNING: Do not attempt to tighten drill bits (or any other accessory) by gripping
the front part of the chuck and turning the tool on. Damage to the chuck and personal
injury may result. Always lock off trigger switch when changing acces sories.
Be sure to tighten chuck with one hand on the chuck sleeve and one hand holding the
tool for maximum tightness.
CHUCK REMOVAL (FIG. 4, 6)
Turn the adjustment collar (D) to the “drill” position and gear shifter (E) to position 1
(low speed). Tighten the chuck around the shorter end of a hex key (not supplied) of
6 mm or greater size. Using a wooden mallet or similar object, strike the longer end in
the clockwise direction, as shown. This will loosen the screw inside the chuck.
Open chuck jaws fully, insert screwdriver (or Torx tool if required) into front of chuck
between jaws to engage screw head. Remove screw by turning clockwise (left-hand-
thread). Place hex key in chuck and tighten, as shown in Figure 6. Using a wooden
mallet or similar object, strike key sharply in the counterclockwise direction. This will
loosen the chuck so that it can be unscrewed by hand.
FIG. 7 FIG. 6
CHUCK INSTALLATION (FIG. 7)
Screw the chuck on by hand as far as it will go and insert screw (left-hand thread).
Tighten screw securely. Tighten the chuck around the shorter end of a 6.4 mm)
or larger hex key (not supplied) strike the longer end in the clockwise direction
with a wooden mallet, as shown. Tighten the screw once again by turning in a
counterclockwise direction.
Drill Operation (Fig. 2)
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories.
WARNING: To reduce the risk of personal injury, ALWAYS ensure workpiece is
anchored or clamped firmly. If drilling thin material, use a wood “back-up” block to
prevent damage to the material.
Turn the collar (D) to the drill bit symbol for drilling. Select the desired speed/torque
range using the gear shifter (E) to match the speed and torque to the planned operation.
1. Use sharp drill bits only. For WOOD, use twist drill bits, spade bits, or hole saws.
For METAL, use high-speed steel (HSS) twist drill bits or hole saws.
2. Always apply pressure in a straight line with the bit. Use enough pressure to keep
drill biting, but do not push hard enough to stall the motor or deflect the bit.
3. Hold tool firmly with both hands to control the twisting action of the drill.