DeWalt XR Li-Ion DCD710-XE, Инструкция по эксплуатации

Страница: 10 / 16

8
To select reverse, depress the forward/reverse control button on the left side of the
tool. The center position of the control button locks the tool in the off position. When
changing the position of the control button, be sure the trigger is released.
NOTE: The first time the tool is run after changing the direction of rotation, you may
hear a click on start up. This is normal and does not indicate a problem.
Worklights (Fig. 2)
There is one worklight (C) located around the chuck collar (D). The worklight will
activate when the trigger switch is pulled.
NOTE: The worklights are for lighting the immediate work surface and are not
intended to be used as a flashlight.
Torque Adjustment Collar (Fig. 2, 4)
The torque adjustment collar (D) is clearly marked with
D
E
FIG. 4
numbers and a drill bit symbol. The collar should be rotated
until the desired setting is located at the top of the tool
(Fig. 2). Locators are provided in the collar to eliminate the
guess work when selecting fastening torque. The higher the
number on the collar, the higher the torque and the larger the
fastener which can be driven. To lock the clutch for drilling
operations, move to the drill bit position.
NOTE: When using the drill/driver for drilling holes, be sure
that the torque adjusting collar is set so the figure of the drill is
aligned with the center line on the top of the tool. Failure to do
this will allow the clutch to slip while attempting to drill.
Dual Range Gearing (Fig. 2, 4)
The dual range feature of your driver/drill allows you to shift gears for greater versatility.
To select the low speed, high torque setting, turn the tool off and permit to stop. Slide
the gear shifter (E) forward (towards the chuck). To select the high speed, low torque
setting, turn the tool off and permit to stop. Slide the gear shifter back (away from
chuck).
NOTE: Do not change gears when the tool is running. If you are having trouble changing
gears, make sure that the dual range gear shifter is either completely pushed forward or
completely pushed back.
OPERATION
WARNING: To reduce the risk of serious personal injury, place the forward/
reverse button in the lock-off position or turn tool off and disconnect battery pack
before making any adjustments or removing/installing attachments or accessories.
Installing and Removing the Battery Pack (Fig. 3)
NOTE: Make sure your battery pack is fully charged.
To install the battery pack (H) into the tool handle, align the battery with the rails
inside the tool’s handle and slide it firmly into the handle until you hear the lock snap
into place.
FIG. 3
G
H
To remove the battery pack from the tool, press the release button (G) and firmly pull
the battery pack out of the tool handle. Insert it into the charger as described in the
charger section of this manual.
Variable Speed Trigger Switch (Fig. 2)
To turn the tool on, squeeze the trigger switch (A). To turn the tool off, release the
trigger switch. Your tool is equipped with a brake. The chuck will stop when the trigger
switch is fully released. The variable speed switch enables you to select the best
speed for a particular application. The more you squeeze the trigger, the faster the
tool will operate. For maximum tool life, use variable speed only for starting holes or
fasteners.
NOTE: Continuous use in variable speed range is not recommended. It may damage
the switch and should be avoided.
Forward/Reverse Control Button (Fig. 2)
A forward/reverse control button (B) determines the direction of the tool and also
serves as a lock off button.
To select forward rotation, release the trigger switch and depress the forward/reverse
control button on the right side of the tool.