DeWalt LaserChalkLine DW088, Инструкция по эксплуатации

Страница: 52 / 216

50
EngLIsh
For the most accurate results, start the work using the wide setting and finish in the
narrow setting.
Magnets
The magnets 24 allow the detector to be mounted to the metal tracks during the
installation of a suspended ceiling.
Detector Operation (Fig. F)
1. Set up and position the laser.
2. Turn the detector on by pressing the power button
21 .
3. Position the detector so that the sensor window 25 is facing the laser beam. Move the
detector up or down within the approximate area of the beam, until you have centered
the detector. For information about the display window indicators and the audible
signal indicators, refer to the table titled
Indicators .
INDICATORS
Above Grade
Slightly Above
Grade On Grade
Slightly below
Grade Below Grade
audible
signals
fast beep fast beep steady tone slow beep slow beep
display
icons
1. Use the marking notches 20 to accurately mark the position of the laser beam.
Mounting on a Grade Rod (Fig. F, G)
1. To secure your detector to a grade rod, first attach the detector to the clamp by pushing
in on the clamp latch
26
. Slide the tracks
27
on the clamp around the rail
28
on the
detector until the latch 29 on the clamp pops into the latch hole 30 on the detector.
2. Open the jaws of the clamp by turning the clamp knob 31 counterclockwise.
3. Position the detector at the height needed and turn the clamp knob clockwise to
secure the clamp on the rod.
4. To make adjustments in height, slightly loosen the clamp, reposition and retighten.