Place the accessory bag holder into the hole
of bracket.(See Illustration F.2)
ACCESSORY BAG HOLDER ASSEMBLY
WARNING:
1. The filter must always be in correct position to
reduce the risk of leaks and possible damage
to vac. Make sure that the filter is completely
covering the filter cage. Make sure there are
no gaps between the filter and the lid. It is
very important to assemble the filter to the
cage without any possible leaks or tears.
Any leaks will allow the picked up debris
to be blown out of the blowing port and back
into the surrounding environment.
2. When using the vac to pick up fine dust,
it will be necessary to empty the dust tank and
clean or replace the filter at more frequent
intervals to maintain peak vac performance.
4. To clean the cartridge filter, shake or brush off
excess dirt or rinse (from the inside of the filter)
with water, dry completely (approximately 24
hours) and re-install.
1. With the power head in an upside down position,
slide the cartridge filter down over the filter cage,
push the filter seals against the power head.
2. Turn the knob on filter cage clockwise to
tighten the filter into place.
3. To remove the filter for cleaning, turn the filter
knob counter clockwise till feel the tactile and
auditory cue, and make sure the knob arrow
align with the "Unlock" icon on the filter cage,
then slide the cartridge filter off the filter cage.
then grasp the step of knob tightly with fingers
to pull the cartridge filter out off the cage.
The cartridge filter can be used for wet or dry pick-up,
installation is the same for both.
To reduce the risk of fire or explosion, do not
operate this vac in areas with flammable gases,
vapors or explosive dust in the air. Flammable
gases or vapors include but are not limited to:
lighter fluid, solvent-type cleaners, oil-based
paints, gasoline, alcohol or aerosol sprays.
Explosive dusts include but are not
limited to: coal, magnesium, aluminum, and
grain or gun powder. Do not vacuum
explosive dust, flammable or combustible
liquids or hot ashes. Do not use this vac as
a sprayer for any flammable or combustible
liquid. To reduce the risk of health hazards
from vapors or dusts, do not vacuum
toxic materials.
DRY PICK-UP
INSTALLING THE CARTRIDGE FILTER
NOTICE:
A dry filter is necessary to pick up dry material. If
use the vac to pick up dust when the filter is
wet, the filter will clog quickly and be very difficult
to clean. If the filter gets wet, replace it before
continuing to do dry pickups.
NOTICE:
If the filter has been used for wet pick-up, it must
be cleaned and dried before dry pick-up.
WARNING:
The operation of any utility vac can result in
foreign objects being blown into the eyes, which
can result in severe eye injury. Always wear safety
goggles complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
starting operation.
CAUTION:
To reduce the risk of hearing loss, wear ear
protectors when using the vac for extended
hours or when using it in a noisy area. The unit
is ready for dry vacuuming.
After plugging the power cord into the wall
receptacle, turn the unit “ON” by pushing the
switch position with 1 embossing straps is
the “ON” position.
ON
OFF
ENGLISH
4
Lock
F.1
F.2
