5
ENGLISH
10. Remove pump out of tank. Remove and replace gasket.
(Fig. CC)
11. Slide piston rod assembly down and out of grommet
and remove from tank. (Fig. DD)
12. Carefully remove and replace o-ring from piston.
Lubricate o-ring with petroleum jelly. (Fig. EE)
13. Remove grommet from tank using pliers to grasp the
head of the grommet while flexing the grommet out of
the hole in the tank. Press or tap new grommet into tank.
Lubricate hole in grommet with petroleum jelly. (Fig. FF)
14. Insert piston rod assembly into tank and through
grommet. (Fig. GG)
15. Reassemble pump with gasket into tank. (Fig. HH)
for correct orientation. Tighten pump nut securely with
adjustable wrench while holding pump to maintain
correct orientation. Push piston assembly into pump.
4. Position pump handle to the furthest downward position.
Remove pump handle from sprayer. (Fig. W)
5. Disassemble carry handle by removing the (6) screws.
(Fig. X)
6. Remove hitch pin and lift pivot clip off of the piston rod.
(Fig. Y)
7. Pull upward to slide piston rod out of pump. (Fig. Z)
8. While holding onto the pump, use an adjustable wrench
to unthread pump nut from pump. Remove nut, hose and
barb assembly. (Fig. AA)
9. Inspect both o-rings on barb assembly. If damaged,
replace hose assembly. (Fig. BB)
Fig. W
Fig. Y
Fig. X
Fig. Z
Fig. AA
Fig. BB
16. Attach pivot clip to piston rod and insert hitch pin.
The orientation of piston rod must match the pivot
clip. (Fig. Y)
17. Reassemble carry handle onto tank. Tighten all six
screws. (Fig. X)
18. To reinstall the agitator, line the notch up on the
agitator with the swedge on piston rod and snap into
place. (Fig. V)
19. Reinstall pressure chamber as outlined in the
Pressure Chamber Maintenance
section. (Fig. S)
Fig. FF
Fig. GG
Fig. HH
Fig. CC
Fig. DD
Fig. EE
Fig. T
Fig. U
Fig. V
