ENGLISH
5
5.
Fan Connection:
Plug fan directly into
NOTE:
To prevent overloading a circuit, do
not plug the fan into a circuit that is servicing
other electrical loads.
120 volt A.C., 60Hz wall outlet. Be sure plug
fits tightly in outlet. A loose connection may
cause overheating and damage to the plug
or fan.
6.
Turning Fan On:
Place fan on stable
level surface. Plug fan into properly grounded
outlet. To start the fan, turn the switch from
the OFF position to the desired fan speed.
7.
Turning Fan Off:
To turn the fan off, turn
the switch from the current fan speed setting
to the off position. Remove plug from outlet.
8.
Adjusting Fan Tilt:
Loosen the
adjustment knob until the drum rotates freely
on the frame. Adjust the fan to desired tilt
angle and re-tighten the knob. Do not
overtighten adjustment knob.
CARE and MAINTENANCE
Cleaning:
Before cleaning the fan be sure
to disconnect power cord from the plug.
Clean the grille surface with a clean damp cloth.
Do not use harsh chemical or abrasive cleaners.
Maintenance:
The Internal motor bearings
Repair:
DO NOT OPERATE THE FAN
WITHOUT THE GRILLE IN PLACE. DO NOT
USE THE FAN IF IT HAS MALFUNCTIONED
OR BECOME DAMAGED IN ANY WAY.
Storage:
Keep original carton for storage
of the fan. Coil and tie the power cord to avoid
damage during storage.
Free warning label replacement:
If
warning labels become illegible or are missing,
please call 1-888-899-0146 for free
replacement.
are permanently lubricated at the factory and
do not require any additional lubrication.
WARNING:
DO NOT IMMERSE THE FAN
OR ANY WIRES IN WATER. Replace front grille
before fan use and allow fan to dry completely
before use. Periodic grille cleaning with a
vacuum will prevent dust build up. The motor
is sealed and does not require any interior
maintenance, cleaning or lubrication.
WARNING:
WARNING:
OPTIONAL ACCESSORIES
TROUBLESHOOTING
If the supply cord is damaged, it
Since accessories, other than
WARNING:
WARNING:
those offered by D
E
WALT, have not been
tested with this product, use of such
accessories with this appliance could be
hazardous. To reduce the risk of injury, only
D
E
WALT recommended accessories should be
used with this product.
TO REDUCE THE RISK OF INJURY
FROM MOVING PARTS AND/OR
ELECTRICAL SHOCK, TURN POWER
SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL
OUTLET BEFORE PERFORMING
TROUBLESHOOTING CHECKS.
Minor problems often can be fixed without
calling customer service.
WARNING:
must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
PROBLEM
CAUSE
SOLUTION
1. Plug unit in.
2. Place in "ON"
position.
1. Contact customer
service.
1. Contact customer
service.
1. Check for
obstructions. If you
find an obstruction,
turn the fan off. Unplug
the fan and carefully
remove the obstruction.
Plug the fan in and turn
it on again by referring
to the operating
instructions.
Unit will not
run.
Unit is not
rotating.
Unit runs but
the fan
makes loud
scraping
noise.
Unit runs but
vibrates
excessively.
1. No power to unit.
2. Switch not on.
1. Obstructions are
keeping the fan
from working.
1. Unit has been
severely jolted
causing fan blade
to rub against
housing or
housing to deform.
1. Dirt build up on
fan blade.
2. Severe jolt has
bent motor shaft.
YEAR
LIMITED
GUARANTEE
5
TOOL GUARANTEE
