English
4
13. Apparatus shall not be exposed to dripping or splashing and no
objects filled with liquids, shall be placed on the apparatus.
This Class B digital apparatus complies with Canadian ICES-003.
CAN ICES-3(B).
NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and the
receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
•
Consult the dealer or an experienced radio/TV technician
for help.
NOTICE:
Per FCC Part 15, changes or modifications to this equipment
not expressly approved by DeWALT could void your authority to operate
this equipment.
READ ALL INSTRUCTIONS
Specific Safety Instructions for Power Cords
•
Don’t abuse the cord.
Protect the power cord from being walked
on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus. Don’t abuse the power
cord. Never carry the apparatus by cord or yank it to disconnect from
receptacle. Keep the cord from heat, oil, and sharp edges. Pull by
plug rather than cord when unplugging the unit.
•
Ground fault circuit interrupter (GFCI)
protection should be
provided on the circuits or outlets to be used. Receptacles are
available having built in GFCI protection and may be used for this
measure of safety.
DANGER –
Never alter AC Power Cord or plug provided. If it will
not fit the outlet, have a proper outlet installed by a qualified electrician.
Improper connection can result in a risk of an electric shock.
EXTENSION CORDS
An extension cord should not be used unless absolutely
necessary.
Use of an improper extension cord could result in a risk
of fire and electric shock, and will void warranty.
If an extension cord must be used, make sure your extension cord
is in good condition. When using an extension cord, be sure to use
one heavy enough to carry the current your product will draw. An
undersized cord will cause a drop in line voltage resulting in loss of
power and overheating. The following table shows the correct size
to use depending on cord length and nameplate ampere rating. If in
doubt, use the next heavier gauge. The smaller the gauge number,
the heavier the cord.
DXAEC210_ManualENFRSP_092116.indd 4
10/19/2016 3:58:52 PM
