Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
•
Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water.
Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING:
Use of this tool can generate and/or disperse dust,
which may cause serious and permanent respiratory or other
injury. Always use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away from face
and body.
WARNING: Always wear proper personal hearing protection
that conforms to ANSI S12.6 (S3.19) during use.
Under some
conditions and duration of use, noise from this product may
contribute to hearing loss.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts
A ......................amperes
Hz ................. hertz
W .....................watts
min ............... minutes
or AC ..........alternating
or DC ... direct current
current
................. Class I Construction
or AC/DC ...alternating
..................... (grounded)
........................
or direct
................. Class II Construction
current
(double insulated)
no ....................no load
…/min ........... per minute
speed
BPM ............. beats per minute n
......................rated
OPM ............. oscillations per minute
........................
speed
RPM ............. revolutions per
.....................earthing
minute terminal
sfpm ............. surface feet
.....................safety alert
.....................
per minute
symbol
SPM ............. strokes per minute
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Motor
Be sure your power supply agrees with the nameplate marking.
Voltage decrease of more than 10% will cause loss of power and
overheating. D
E
WALT tools are factory tested; if this tool does not
operate, check power supply.
FIG. 1
A
D
F
C
E
B
G
English
4
