DeWalt DW849-XE, Инструкция по эксплуатации

Страница: 7 / 12

5
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ................. volts A ...............amperes
Hz ............... hertz W ..............watts
min ............. minutes ...........alternating current
.......... direct current
no ..............no load speed
.............. Class I Construction .............earthing terminal
................... (grounded) .............safety alert symbol
............... Class II Construction …/min .......revolutions per minute
................... (double insulated) BPM ..........beats per minute
Components (Figure 1)
A. Speed control wheel
B. Trigger switch
C. Brush inspection cap
D. Auxiliary handle
E. Spindle lock
A
B
C
D
E
FIGURE 1
OPERATION
WARNING: Shock Hazard. To reduce the risk of serious personal injury, turn
tool off and disconnect tool from power source before making any adjustments or
removing/installing attachments or accessories.
Auxiliary Handle (Figure 1)
An auxiliary handle (D) is supplied with your tool and can be installed on either side
of the front housing. This handle should be used at all times to maintain complete
control of the tool.
Variable Speed Switch (Figure 2)
F
B
FIGURE 2
This tool is equipped with a variable speed
switch that permits speed control from zero to
1000/3000 RPM. To turn the tool on, squeeze
the trigger switch shown in Figure 2 until the tool
starts to run. The farther you depress the trigger,
the faster it will operate. Releasing the trigger
turns the tool off.
Use lower speeds for applying liquid waxes and
polishes and higher speeds for removing dried
liquid. Use the highest speed (fully depress
trigger) for buffing the car to a final lustre.
The tool can be locked on for continuous use by squeezing the trigger switch fully
and depressing the lock button (F) shown in Figure 2. Hold the lock button in as
you gently release the trigger switch. The tool will continue to run. To turn the tool
off from a locked on position, squeeze and release the trigger switch once. Do not
unplug the tool with the switch in the locked on condition. Make sure the tool is not
locked on when plugging in. A locked on tool will start immediately when plugged in.
NOTE: The trigger can only be locked on with the tool running at the maximum
RPM.
Speed Control Wheel (Figure 3)
The maximum speed of your tool can be changed by rotating the speed control
wheel (A) to the desired setting. The wheel incorporates detents to prevent
inadvertent wheel movement and to facilitate speed selection. For added versatility,