English
Slide the tool mount onto the beam by inserting the flat bar
between the T-tracks. Position the tool mount on the right end of
the beam with the tape measure clamp facing toward the left.
Secure the tool mount unit to the beam by turning the locking
knobs until snug.
Holes must be drilled in order to secure the saw to the tool mount.
When properly installed, the saw fence is aligned with the work
support so that the material you cut is square to the saw fence.
(Fig. 3) Before drilling any mounting holes, ensure that the saw
fence is aligned with the vertical face of the work support.
a. Place the saw on the tool mount, centering it left-to-right. Place
a straight edge against the saw fence and align the saw with the
vertical face of the work support. See Figure 3.
b. Mark the mounting holes on the tool mount.
c. Remove the saw and drill 7/16” holes at each location.
d. Place the miter saw on the tool mount.
e. Insert hex head bolts with flat washers through the saw base and
tool mount and loosely install flat washers and self-locking nuts
under the tool mount.
NOTE: The enclosed hardware is designed to secure D
E
Walt miter
saws. Other miter saws may require a different length bolt for
proper fastening. The bolt must be long enough to allow 2 threads
to protrude through the self-locking nut.
f. Re-check saw fence and work support alignment by placing a
straight-edge along the face of the saw fence and the face of the
work support. See Figure 3.
g. Securely tighten the self-locking nuts.
h. Loosen the locking knobs, check movement of the tool mount
along the rail, and tighten the locking knobs.
3
Saw Mounting Instructions: (DW708)
NOTE:The DW730 has been pre-drilled for the DW708 sliding
compound miter saw. The tool mount must re-oriented 180˚
prior to mounting. When mounting the DW708 leave the rear
mounted stabilizer bars attached to the saw to ensure maxi-
mum stability.
1. Remove the two black knobs.
2. Remove the center bolt.
3. Remove the flat bar and rotate the tool mount 180 degrees.
4. Replace the center bolt and tighten it securely.
5. Replace the two black knobs.
Slide the tool mount onto the beam by inserting the flat bar between
the T-tracks. Position the tool mount on the right end of the beam
with the tape measure clamp facing toward the left. Secure the tool
mount unit to the beam by turning the locking knobs until snug.
a. Place the saw on the tool mount and orient it so the enclosed 2 3/4”
hex head bolts can be inserted through the miter saw base and tool
mount. Secure the bolts loosely with the flat washer and self-lock-
ing nuts.
b. Re-check saw fence and work support alignment by placing a
straight-edge along the back of the saw fence and the back of the
work support.
c. Securely tighten the self-locking nuts.
d. Loosen the locking knobs, check movement of the tool mount along
the rail, and tighten the locking knobs.
Mounting all other miter saws
Test fit your miter saw to the tool mount. If all four corners of the saw
are not on the tool mount after alignment of the saw fence and the
work support, the tool mount may need to be re-oriented 180˚.
Remove the saw and perform steps 1 through 5 above before pro-
ceeding.
DW730/MiterSawWkStn 5/2/02 10:48 AM Page 6