DeWalt DW331-XE, Инструкция по эксплуатации

Страница: 9 / 12

7
TO MOUNT THE INSERT INTO THE SHOE
1. Slide the edges (N) into the grooves (O) of the shoe (I).
2. Slide the insert back into position against the shoe.
TO MOUNT THE INSERT INTO THE COVER
1. Slide the edges (N) behind the ribs (P) of the cover (L).
2. Push the front end of the insert towards the cover. The insert snaps into
place.
4. To remove the anti-splinter shoe insert do the above process in reverse order.
FIG. 5A
M
N
O I
FIG. 5B
M
N
P L
Dust Extraction (Fig. 6)
The dust extraction adaptor (Q) in combination with the dust extraction shroud (R)
helps extract the dust from the workpiece surface, when connected to a suitable dust
extraction system.
1. Place the dust extraction shroud (R) onto the finger guard (F) until it clicks in
place.
R
F
Q
FIG. 6
2. Fit the dust extraction adaptor (Q) to the tool as shown.
3. Connect the hose of a suitable dust extraction system to the adaptor.
WARNING: When appropriate, connect a dust extraction system designed in
compliance with the applicable directives regarding dust emission.
WARNING: Do not use a dust extraction system without proper spark protection
when sawing metal.
INSTRUCTIONS FOR USE
WARNING:
• Always observe the safety instructions and applicable regulations.
• Make sure your workpiece is well secured. Remove nails, screws and other
fasteners that may damage the blade.
• Check that there is sufficient space for the blade underneath the workpiece. Do
not cut materials that exceed the maximum cutting depth of the blade.
• Use sharp saw blades only. Damaged or bent saw blades must be removed
immediately.
• Do not use the tool for sawing pipes or tubes.