DeWalt DE7187, Руководство пользователя

Страница: 19 / 72

19
E N G L I S H
• Remove the cover (7).
• Attach the connectors (8) from the switch box to
the connectors (9) of the internal wiring.
• Carefully place the connectors into the provided
area.
• Fit the switch box (2) to the handle using the
screws (6).
Installing the laser head (fig. C1 - C3)
• Loosen the screws (11) and remove them.
• Remove the lower guard (12).
• Loosen the screws (13) and remove them.
• Carefully take off the cavity cover (14).
• Take the connector (15) out of the cavity cover.
Retain the cover for future use in case the laser
head has to be removed.
• Attach the connector (16) of the laser head (5) to
the connector (15) of the internal wiring.
• Carefully place the connector into the provided
area.
• Fit the laser head (5) to the upper guard (17)
using the screws (13).
• Refit the lower guard (12). Tighten the screws (11).
Adjusting the laser head (fig. D1 - D8)
• Adjust the saw head for a vertical crosscut.
• Insert the trigger lock (3) into the padlock hole of
the trigger switch (18). Push the trigger lock (3)
until it snaps into place.
• Switch on the laser.
• Perform the adjustments as described below in
order to achieve correct alignment of the laser line.
• Repeat these adjustments as necessary until the
laser line is correctly aligned.
• Switch off the laser.
• Place the Allen key (4) and the trigger lock (3) in
the storage for future adjustment.
Adjustment perpendicular to the table (fig. D2 & D3)
• Raise the saw head into its upper rest position.
• Place a set square (21) on the table and up
against the fence (22).
Do not touch the tips of the blade teeth
with the square.
• Using the Allen key (4), turn the adjustment screw
(18) as necessary to align the laser line with the
edge of the square.
Adjustment perpendicular to the fence (fig. D4 & D5)
• Pull down the head until the blade just enters the
saw kerf (23).
• Place a set square (21) on the table and up
against the blade (24).
Do not touch the tips of the blade teeth
with the square.
• Using the Allen key (4), turn the adjustment screw
(19) as necessary to align the laser line with the
edge of the square.
Adjustment parallel to the blade (fig. D3 & D6)
• Raise the saw head into its upper rest position.
• Place a set square (21) on the table and up
against the kerf (23), aligning the edge of the
square with the laser line.
• Pull down the head and observe the laser line.
Do not touch the tips of the blade teeth
with the square.
• If the line moves, turn the adjustment screw (18)
as necessary to align the laser line with the edge
of the square.
Aligning the laser line (fig. D7 & D8)
• Pull down the head until the blade just enters the
saw kerf (23).
• Place a set square (21) on the table and up
against the blade (24).
Do not touch the tips of the blade teeth
with the square.
• Turn the adjustment screw (20) as necessary to
align the laser line with the left edge of the blade.
Instructions for use
Always observe the safety instructions
and applicable regulations.
• Make sure the attachment has been set up
securely.