9
English
Proper Hand Position (Fig. H)
WARNING:
To reduce the risk of serious personal
injury,
ALWAYS
use proper hand position as shown.
WARNING:
To reduce the risk of serious personal
injury,
ALWAYS
hold securely in anticipation of a
sudden reaction.
WARNING:
Always use a support.
Proper hand position requires one hand on the main
handle
2
while the other hand presses the die arm
8
or
oils the die
6
.
Fig. G
23
22
4
3
Installing and Removing the Battery Pack
(Fig. G)
nOTE:
The DCE700 uses the DCB609G battery pack only. For
best results, make sure your battery pack is fully charged.
Unlock battery door
3
by moving battery door latch
4
towards the rear of the tool and open as shown in Figure G.
To install the battery pack
22
into the tool, align the
battery pack with the rails inside the tool and slide it in
until the battery pack is firmly seated. Ensure that it does
not disengage.
Close the battery door
3
, and push the battery door
latch
4
forward towards the front of the tool to lock the
battery door.
To remove the battery pack from the tool, unlatch and open
the battery door. Then press the battery release button
23
and firmly pull the battery pack out of the tool. Insert it into
the charger as described in
Charging a Battery
.
Do not leave the battery door open.
21
Fig. F
D
e
WALT Bluetooth® Tool Tag Ready (Fig. F)
Optional Accessory
WARNING:
Read instruction manual for the
D
e
WALT
Bluetooth
®
Tool Tag.
WARNING:
Unplug the charger before installing the
D
e
WALT
Bluetooth
®
Tool Tag.
WARNING:
When installing or replacing the
D
e
WALT
Bluetooth
®
Tool Tag, use only the screws provided. Be
sure to securely tighten the screws.
Your pipe threader comes with mounting holes
21
and
fasteners for installing a
D
e
WALT
Bluetooth
®
Tool Tag
(DCE041). You will need a T15 bit tip to install the tag. The
D
e
WALT
Tool Tag is designed for tracking and locating
professional power tools, equipment, and machines using
the
D
e
WALT
Tool Connect™ app. For proper installation of
the
D
e
WALT
Tool Tag refer to the
D
e
WALT
Tool Tag manual.
Fig. E
10
20
12
11
14
13
28
to the clamp adjustment
11
and push down on the
clamp handle
13
to lock the pipe into position. Force
may be required.
To remove the clamp from the pipe, pull back on the clamp
handle release lever
14
and release the clamp handle.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories.
An
accidental start-up can cause injury.
