DeWalt DC305-XE, Инструкция по эксплуатации

Страница: 11 / 16

9
FIG. 11
FIG. 12
ROCK TOOL UP TO NORMAL CUTTING
POSITION AFTER BLADE HAS CUT THROUGH
MATERIAL
STARTING POSITION FOR POCKET CUTTING
Next, tip the saw backward until the back edge of the shoe is resting on the work surface
and the blade clears the work surface. Now switch motor on, always permitting blade to
attain maximum speed. Grip handle steadily and begin a slow, deliberate upward swing
with the handle of the saw. Blade will begin to feed into material. Always be sure blade is
completely through material before continuing with pocket cut.
NOTE: In areas where blade visibility is limited, use the edge of the saw shoe as a
guide. Lines for any given cut should be extended beyond edge of cut to be made.
METAL CUTTING (FIG. 13)
This unit has different metal cutting capacities depending upon type of blade used and
the metal to be cut. Use a finer blade for ferrous metals and a coarse blade for non-
ferrous materials. In thin gauge sheet metals it is best to clamp wood to both sides of
sheet. This will insure a clean cut without excess vibration or tearing of metal. Always
remember not to force cutting blade as this reduces blade life and causes costly blade
breakage.
FIG. 10
A B
C D
WARNING : Use extra caution when cutting overhead and pay particular attention to
overhead wires which may be hidden from view. Anticipate the path of falling branches
and debris ahead of time.
WARNING : Inspect work site for hidden gas pipes, water pipes, or electrical wires
before making blind or plunge cuts. Failure to do so may result in explosion, property
damage, electric shock, and/or serious personal injury.
FLUSH-TO CUTTING (FIG. 11)
The compact design of the saw motor housing and spindle housing permits extremely
close cutting to floors, corners and other difficult areas.
POCKET/PLUNGE CUTTING – WOOD ONLY (FIG. 12)
The initial step in pocket cutting is to measure the surface area to be cut and mark clearly
with a pencil, chalk or scriber. Use the appropriate blade for the application. The blade
should be longer than 89 mm (3-1/2") and should extend past the shoe and the thickness
of the workpiece during the cut. Insert blade in blade clamp.