DeWalt DC305-XE, Инструкция по эксплуатации

Страница: 10 / 16

8
WARNING: Cut hazard. Blade breakage may occur if the blade does not extend
past the shoe and the workpiece during the cut (Fig. 5). Increased risk of personal
injury, as well as damage to the shoe and workpiece may result.
CAUTION: Cut hazard. Lock trigger switch and disconnect battery pack from tool
before making any adjustments, changing accessories, servicing, or moving the
tool. Such preventative safety measures reduce the risk of starting the tool accidentally.
TO INSTALL BLADE INTO SAW
FIG. 6
C
1. Open blade clamp release lever (C) up (Fig. 6).
2. Insert blade shank from the front.
3. Close blade clamp release lever down.
NOTE: The blade can be installed in four positions as
shown in Figure 10.
TO REMOVE BLADE FROM SAW
CAUTION: Burn hazard. Do not touch the the blade
immediately after use. Contact with the blade may result
in personal injury.
1. Open up blade clamp release lever (C).
2. Remove blade.
FIG. 7
Cutting with Blade in Horizontal Position (Fig. 7)
Your saw may or may not be equipped with a horizontal blade clamp. Installing a blade
in the horizontal orientation allows cutting close to floors, walls or ceilings where limited
clearance is available. Ensure that the shoe is pressed against the framing to avoid
kickback.
Adjustable Shoe (Fig. 8)
FIG. 8
CAUTION: Cut hazard. Lock trigger switch
and disconnect battery pack from tool before
making any adjustments, changing acces-
sories, servicing, or moving the tool. Such
preventative safety measures reduce the risk of
starting the tool accidentally.
Your saw may or may not come with an
adjustable shoe. The shoe will adjust to limit
the depth of cut. Hold the saw with the under-
side facing up. Push the button on the hand grip and slide the shoe out to one of the
three settings and release the button.
CAUTION: Cut hazard. To prevent loss of control, never use tool without shoe.
FIG. 9
Cutting (Fig. 9)
WARNING : Always wear eye protection that conforms to ANSI Z87.1 (CAN/CSA
Z94.3) while operating this power tool.
WARNING : Exercise extra caution when cutting towards operator. Always hold saw
firmly with both hands while cutting.
Before cutting any type of material, be sure it is firmly anchored or clamped to prevent slip-
ping. Place blade lightly against work to be cut, switch on saw motor and allow it to obtain
maximum speed before applying pressure. Whenever possible, the saw shoe must be held
firmly against the material being cut. This will prevent the saw from jumping or vibrating and
minimize blade breakage. Any cut which puts pressure on the blade such as angle or scroll
cuts increase potential for vibration, kickback, and blade breakage.