DeWalt D25901-XE, Инструкция по эксплуатации

Страница: 8 / 12

6
Setting the Electronic Impact Energy Control Dial
D25901 (FIG. 1)
Turn the dial (C) to the desired level. The higher the number, the greater the impact
energy. With dial settings from 1 (low) to 7 (full power) the tool is extremely versatile
and adaptable for many different applications.
The required setting is a matter of experience, for example:
• when chiselling soft, brittle materials or when minimum break-out is required, set
the dial to 1 or 2 (low);
• when breaking harder materials, set the dial to 7 (full power).
Fitting and Adjusting the Side Handle (Fig. 7)
The side handle (F) can be mounted on the front of the machine to suit both right- and
left-hand users.
WARNING: Always operate the machine with the side handle properly mounted.
1. Unscrew the side handle clamp knob (J).
2. Slide the side handle assembly onto the machine locating the steel ring (I) in the
mounting area (X). The correct position of the side handle is between head and
middle of the tube.
3. Adjust the side handle (F) to the desired angle.
F
J
I
FIG. 7
4. Slide and rotate the side handle to the desired position.
5. Lock the side handle in place by tightening the clamp knob (J).
Instructions for Use
WARNING: Always observe the safety instructions and applicable regulations.
WARNING: Be aware of the location of pipework and wiring.
WARNING: Apply a pressure of approx. 20–30 kg. (44–66 lbs.) to the tool.
Excessive force does not speed up chiselling but decreases tool performance and
may shorten tool life.
Switching On and Off (Fig. 1)
To turn the tool on, set the on/off switch (A) to position 1. To turn the tool off, set the
on/off switch (A) to position 0.
Demolition, Chasing and Channelling (Fig. 1)
WARNING: Ensure that the cutting edge does not show discoloration caused by
too much pressure. This may impair the hardness of the accessory.
Various types of chisels are available as an option.
1. Select the appropriate chisel. Clean and grease its shank.
2. Insert the chisel and check whether it is properly locked.
3. Set the desired impact energy level.
4. Fit and adjust the side handle (F) and make sure it is firmly tightened.
5. Hold the tool at both handles (B, F) and switch on. The tool now runs in
continuous operation.
6. Always switch off the tool when work is finished and before unplugging.
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect battery pack before making any adjustments or removing/installing
attachments or accessories.
Lubrication
Your power tool requires no additional lubrication.