DeWalt D25901-XE, Инструкция по эксплуатации

Страница: 7 / 12

5
FIG. 3
D25901
E
FIG. 2
D25901
2. Insert the chisel shank into the tool holder/sleeve (E). Press and turn the chisel
slightly until the sleeve snaps into position.
3. Pull on the chisel to check if it is properly locked. The hammering function
requires the chisel to be able to move axially several centimeters when locked in
the tool holder.
4. To remove a chisel, pull back the tool holder/sleeve (E) and pull the chisel out of
the tool holder.
Inserting and Removing 19 mm Hex Accessories
CAUTION: To reduce the risk of tool damage, only use 19 mm (3/4 " ) hex shank
accessories with the D25941.
D25941 (FIG. 4, 5)
This machine uses chisels with a 19 mm hex shank (refer to the inset in Figure 5
for a cross-section of a chisel shank).
1. Clean and grease the chisel shank.
CAUTION: Do not apply lubricant to the machine.
2. Pull back the tool holder/sleeve (E), align the groove (G) with the yellow marker
(H) and insert the chisel shank into the tool holder. Release the locking sleeve.
3. Pull on the chisel to check if it is properly locked. The hammering function
requires the chisel to be able to move axially several centimetres when locked in
the tool holder.
FIG. 4
D25941
19 mm
FIG. 5
G
H
D25941
E
4. To remove a chisel, pull back the tool holder/sleeve (E) and pull the chisel out of
the tool holder.
Indexing the Chisel Position (Fig. 6)
The chisel can be indexed and locked into 12 different positions.
1. Insert the chisel as described above.
2. Rotate the chisel position collar (D) in the direction of the arrow until the chisel is
in the desired position.
D
FIG. 6