4
Switch
To start the rotary hammer, depress the trigger switch (D). To stop rotary hammer,
release the switch.
VARIABLE SPEED TRIGGER
The
variable speed trigger switch
(D) permits speed control. The farther the trigger
switch is depressed, the higher the speed of the drill.
NOTE:
Use lower speeds for starting holes without a centerpunch, drilling in metal,
plastics or ceramics, or driving screws. Higher speeds are better for drilling in
masonry for maximum efficiency.
Lock-on Button
WARNING:
Be sure to release the locking mechanism before disconnecting the
plug from the power supply. Failure to do so will cause the hammerdrill to start
immediately the next time it is plugged in. Damage or personal injury could result.
The lock-on button is for use only when the rotary hammer is stationary, mounted in a
drill press stand or for chipping applications.
Before using the tool each time, be sure that the lock-on button release mechanism is
working freely.
D25113-XE, D25114-XE ONLY (FIG. 1)
To lock the trigger switch in the ON position for continuous operation, depress the
trigger switch and slide the lock-off button (F) up. The tool will continue to run. To
turn the tool OFF from a locked ON condition, squeeze the trigger once then release it.
D25330-XE ONLY (FIG. 4)
To lock the trigger switch in the ON position for continuous operation, depress the
trigger switch and push the lock-on button (F) in. The tool will continue to run.
Reversing Lever
(D25113-XE, D25114-XE, D25213-XE, D25314-XE, D25315-XE)
The reversing lever is used to reverse the rotary hammer for backing out screws or
jammed bits. It is located above the trigger, shown in Figure 2.
CAUTION:
When reversing to clear jammed bits, be ready for strong reactive
torque.
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ................. volts
A ...............amperes
Hz ............... hertz
W ..............watts
min ............. minutes
...........alternating current
.......... direct current
no ..............no load speed
.............. Class I Construction
.............earthing terminal
...................
(grounded)
.............safety alert symbol
............... Class II Construction
…/min .......revolutions per minute
...................
(double insulated)
BPM ..........beats per minute
Motor
Your D
E
WALT tool is powered by a D
E
WALT-built motor. Be sure your power supply
agrees with the nameplate markings. Voltage decrease of more than 10% will cause
loss of power and overheating. All D
E
WALT tools are factory tested.
INTENDED USE
WARNING:
Never modify the power tool or any part of it. Damage or personal injury
could result.
These heavy-duty rotary hammers have been designed for professional drilling
and hammerdrilling, screwdriving and light chipping at various work sites (i.e.,
construction sites).
DO NOT
use under wet conditions or in presence of flammable
liquids or gases.
These heavy-duty rotary hammers are professional power tools.
DO NOT
let children
come into contact with the tool. Supervision is required for those under 16 years of
age.
Side Handle
CAUTION:
Always operate the tool with the side handle properly assembled. Hold
tool with both hands to maximize control.
A side handle (A) is supplied with this rotary hammer. It clamps to the front of the gear
case without depth rod (B) as shown in Figure 1 and can be rotated 360° to permit right-
or left-hand use. The side handle can be tightened by rotating the black plastic portion of
the side handle clockwise and loosened by rotating it counterclockwise.
Содержание D25113-XE
Страница 11: ......
