Devon BLAZER 9000, Руководство оператора

Страница: 8 / 19

8
Air Connections
1. The Blazer 9000 has air safety releases, which require that an air system be installed.
2. The air valve can be mounted on the optional power unit stand referenced above.
3. Maximum air pressure on the system is 50
-60
PSI. Use regulator to control pressure and water
filter to keep system dry.
4. Reference page #11 for the air schematic and required connections.
Surface Mounting
1. Lifts that cannot be recessed must utilize the optional ramps that will be anchored to the concrete
floor. Each ramp is anchored utilizing two 5/8” anchor bolts. The ramp is butted against the lift
base, which provides the means for the vehicle to roll on the lift.
II. Owner/Employer Responsibilities
The owner/employer shall:
1. Ensure that lift operators are instructed in the safe use and operation of the lift using the
manufacturer instructions and safety tips.
Display a copy of the manual in a location convenient to the lift so the operators can refer to it
as required.
2. Establish procedures to maintain, inspect and care for the lift in accordance with the
manufacturers recommended procedures to ensure its continued safe operation.
3. Provide necessary lock out/tagouts of energy sources per ANSI Z244.1-1982 before beginning any
lift repairs.
4. Not modify the lift in any manner without prior written consent of the manufacturer.
5. Ensure that there is adequate drainage around the lift so water will not accumulate on the base of
the lift.
6. In the unlikely event that one side of the lift will not lower all the way to the floor, slowly crack the
hydraulic line (at the power unit) on the line coming from that side of the lift and allow oil to
escape until it reaches he floor.