Speaker pole mount
The Devine Onyx subwoofers are equipped with a pole mount with an M20 screw thread. This means that a
suitable speaker pole can be screwed in securely to provide a stable platform for mounting a full-range
speaker on top. Due to a subwoofer's heavier weight and larger dimensions, this setup is space-saving as
well as stable. Naturally, the subwoofer needs to be placed on a flat surface that is capable of holding the
weight of the subwoofer with a speaker on top.
Voltage switch
The subwoofer is equipped with a voltage switch for extra versatility. By default, it should be set to 230V and
need no adjustment. In case of doubt, please contact your dealer.
Audio technology
The Onyx speaker series features the very latest in audio technology. By adhering to the following tips and
instructions, you can make the most of everything this subwoofer has to offer for the very best audio and
performance quality possible.
LED indicators
The green LED on the speaker will light up whenever the subwoofer is connected to an active power source
and turned on.
The red LED on the speaker is an indicator for the clip limiter and will light up whenever the amplifier module
is overloaded by an input signal that is too loud. In this case, appropriate adjustments should be made until
the red LED indicator no longer lights up.
Continually overloading the amplifier module and causing the red LED to light up is likely to cause permanent
damage to both the amplifier module and the speaker components and shorten their lifespan considerably.
Damage caused by negligent use is not covered by the warranty.
Connectors
The Onyx subwoofers support 2.1 setups (1 sub 2 speakers) and are equipped with functions and
connectors specifically for this purpose. The sound source should be connected to the subwoofer first via the
two input connectors where the low tones will be filtered out. The speakers should then be connected to the
subwoofer's outputs.
Outputs:
The Onyx series subwoofer's outputs are designed for connecting powered satellite or full range speakers.
They filter out the low frequencies so that each part of your system can focus on the frequencies it
reproduces best for optimal results.
Link out
The Link outputs are designed for connecting additional (full-range) speakers or subwoofers. The link outputs
do not filter out the low frequencies like the filter outputs do so that (full-range) speakers and subwoofers
connected to the link outputs receive the full signal that they can then filter themselves. If the standard
filtered outputs are used with a subwoofer there will be nothing left for it to output.
When using a microphone
It's not possible to connect a microphone directly to the Onyx subwoofer. This should be done via a PA mixer
so that the volume and sound can be controlled. The mixer's main output can be connected directly to the
subwoofer.
For optimal sound quality, a microphone should be placed at a maximum distance of 5 cm away from the
mouth and spoken into at a sufficient volume so that minimal amplification is necessary. A microphone is
directional and will not usually capture much sound from the back or sides.
Microphones should never be held directly in front of a speaker as this can cause feedback, which results in
a loud, high-pitched tone. Should this happen accidentally, remove the microphone from the vicinity of the
speaker immediately and turn down the volume control.
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 23-09-2017 RV
Revision date and author's initials: -
